El handbroms service läge

[Klason]

Har försökt att få handbromsen i serviceläge enligt en bra instruktion på forumet.Får det inte att funka,vet inte vad för fel jag gör.
Mondeo-16 aut nyckel lös.

[RickardEM]

Har försökt att få handbromsen i serviceläge enligt en bra instruktion på forumet.Får det inte att funka,vet inte vad för fel jag gör.
Mondeo-16 aut nyckel lös.

Fungerar det bättre att följa den här guiden?

Activation
WARNING: Service actions on vehicles equipped with electronic parking brakes may cause unexpected parking brake application, which could result in injury to hands or fingers. Put the electronic parking brake system into service mode prior to servicing or removing rear brake components. Failure to follow this instruction may result in serious personal injury.
NOTE: EPB (electronic parking brake) service mode is also known as EPB maintenance mode. NOTE: Carry out the following service mode deactivation procedure to activate the EPB system.
1 - Set the ignition to ON.
2 - Press and hold the brake pedal.
3 - Press the EPB switch to release the parking brake.
4 - Release the brake pedal and the EPB switch.
5 - Press and hold the accelerator pedal and place the EPB switch to the RELEASE (downward) position. Continue to hold the accelerator pedal and EPB.
6 - Set the ignition to OFF then set the ignition to ON within 5 seconds. Continue to hold the accelerator pedal and the EPB switch.
NOTE: When replacing rear brake pads in service (maintenance) mode, the brake caliper piston must be compressed into the caliper housing. The brake caliper piston does not have to be rotated while compressing the piston.
NOTE: The EPB system will be deactivated, preventing parking brake application until service has been completed and service (maintenance) mode has been deactivated. Dependent on the cluster fitted to the vehicle the yellow EPB indicator will be illuminated, the red brake warning indicator will flash and Maintenance Mode will display on the message center.

Deactivation
NOTE: Carry out the following service mode activation procedure to deactivate the EPB system.
1 - Set the ignition to ON.
2 - Press and hold the accelerator pedal and place the EPB switch in the APPLY (upward) position. Continue to hold the accelerator pedal and the EPB switch.
3 - Set the ignition to OFF then set the ignition to ON within 5 seconds. Continue to hold the accelerator pedal and the EPB switch.
4 - Continue to hold the accelerator pedal and EPB switch until depending on the cluster fitted to the vehicle, the yellow EPB indicator is no longer illuminated, the red brake warning lamp is no longer flashing and Maintenance Mode is no longer displayed in the message center.
NOTE: The EPB system will fully apply and release the parking brake to guarantee sufficient air gap between the rear brake pads and brake disc.
5. Release the accelerator pedal and the EPB switch.

\Rickard

[MickaelB]

Hejsan, är det någon som fått ovanstående guide att fungera för att få EPB i serviceläge? Jag har en 2016 S-Max och får det inte att fungera,
Är det någon som vet hur man gör för att få handbromsen i service läge?
/Micke

[cox]

Nix det funkar inte, jag använder forscan. Har du inte det, går det att lossa elkontakten och backa motorn ned ett 9 volts batteri

Skickat från min SM-A405FN via Tapatalk

[MickaelB]

Tack för svar, tänkte det...
Skaffade en så nu kan jag sätta epb i service mode

[cox]

Finns mycket skoj att pilla med i forscan

Skickat från min SM-A405FN via Tapatalk